Carburateurs, filtres à air et tringleries d'accélérateur

From this point forward the WT-1242 has been replaced with the WT-1242A. The new version has a dust seal installed on both ends of the throttle shaft to prevent wear and air leaks in dusty conditions. The bottom gasket material has been changed and the debris screen. Lastly the recirculation valve has been updated. We will post pictures and more info of the changes ASAP.   

We're proud to announce the release of the OBR exclusive Wt-1242 carb! This is a modified (not bearing modified) carb directly from Walbro built to OBR specs! We've used nothing but the best parts and this carb comes standard with a spiral diaphragm, all teflon gaskets and an ethanol resistant primmer bulb. We've also modified the metering to deliver the fuel needed for high performance engines. No need to pull your new carb apart and change/cut metering springs. Between the primmer bulb, teflon gaskets and spiral diaphragm running fuel with ethanol is no longer a problem.  We've tested on all of our engines both piston ports and reed with great results. This carb will also run well on stock engines but it will shine on ported engines that need the extra fuel that this carb can supply. 

Billet delrin version is now available and is half the weight of the aluminum version. OBR power stack is compatible with most aftermarket clamp on air filters. This is a bolt on performance item that will improve power on any engine that's stock or fully modified. We spent several months developing this stack on our in-house flow bench and dyno. We've seen more power out of this design than any other stack that we have tested. Dyno graph can be found in the images. Tapered bore increases velocity through the intake tract and gives better consistency. The clamping surface has barbs to prevent the air filters from falling off under hard running. There is no boss on this stack which allows the air filter to be pushed closer to the carb for cars that have minimal air filter clearance.

Jeu de pétales de roseaux de remplacement avec plaques de tension et quincaillerie. Ceux-ci sont compatibles avec nos moteurs de 22,5 cc à 34 cc. Ceux-ci ne sont pas compatibles avec nos anches 46/47cc.

1764 - DT1 Dome Air Filter

2682 - Braap Products Losi MTXL/DBXL Reed Throttle Linkage

2681 - Braap Products Replacement 46cc/47cc Throttle Linkage

Walbro Wt-668 Carb. All Wt-668 carbs come with a choke lever. We send what we have in-stock which is generally black or red. If you have a preference email us when ordering.